Product Specifications

• 128 bits of high-voltage outputs

• High-current drivers (600 mA sink)

• Automatic surge current shutdown protection

• Thermal shutdown protection

• High breakdown voltage (55 V)

• Output clamp diodes for inductive flyback protection

• Compatible with Intelligent I/O Controllers

• Built-in-Test logic for fault isolation

• VMEbus compatible (ANSI/IEEE STD 1014-1987 IEC 821 and 297)

• A24:A16:D32/D16/D08 (EO): slave 39/3D:29/2D:6U form factor

• Optional pull-up resistors for electronic switch outputs

• Front panel with fail LED

• Sockets are provided for warming resistors, which are supplied by the user

Manufactured by GE Fanuc. Refurbished in good condition.

The VMIVME-2128 is a 128-bit High-Voltage Digital Output Board with Built-in-Test.This product complies with the VMEbus specification (ANSI/IEEE STD 1014-1987 IEC 821 and 297) with the following mnemonics: A24:A16:D32/D16/D08 (EO): Slave: 39/3D:29/2D:6U form factor. Two 96-pin female connectors are used with this board. For mass terminations (IDC), an ERNI IDC DIN connector and 0.033-inch 30 AWG ribbon cable are recommended. The ERNI order numbers are: 96-pin connector 96-conductor 0.033-inch cable, 913 031, and 913 049. This board is designed with internal Built-in-Test logic that supports testing of all the on-board active components except the output drivers. All Output Data Registers have read-back capability. Thus, the user can monitor the data written to this board and determine if it is functioning properly. A front panel Fail LED is provided to help in isolating a faulty board. This LED is illuminated at power up and can be extinguished under program control upon the successful completion of user-defined diagnostic software.

SKU#1B

Qty 1

Alternative P/N #: VMIVME-2128, VMIVME2128, VMIVME 2128